Latest Certified Success Dumps Download

CISCO, MICROSOFT, COMPTIA, HP, IBM, ORACLE, VMWARE
200-401 Real Tests (May 2017)

[Free] 2017(May) Ensurepass Examcollection Cisco 200-401 Real Tests 11-20

May 3, 2017

Ensurepass
2017 May Cisco Official New Released 200-401 Q&As
100% Free Download! 100% Pass Guaranteed!
http://www.ensurepass.com/200-401.html

Managing Industrial Networks with Cisco Networking

QUESTION 11

Refer to the exhibit. An industrial ruggedized network device needs to be installed in the place of the icon labeled Network Device to accommodate a leased line attachment to the Internet. Which network device and interface configuration meets the minimum requirements for this installation?

 

clip_image001

 

A.

a router with two Ethernet interfaces

B.

a switch with two Ethernet interfaces

C.

a router with one Ethernet and one serial interface

D.

a switch with one Ethernet and one serial interface

E.

a router with one Ethernet and one modem interface

 

Correct Answer: C

 

 

QUESTION 12

Refer to the exhibit. C-router is to be used as a “router-on-a-stick” to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?

 

clip_image002

 

A.

These commands need to be added to the configuration:C-router(config)# router eigrp 123C-router(config-router)# network 172.19.0.0

B.

These commands need to be added to the configuration:C-router(config)# router ospf 1C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0

C.

These commands need to be added to the configuration:C-router(config)# router ripC- router(config-router)# network 172.19.0.0

D.

No further routing configuration is required.

 

Correct Answer: D

 

 

QUESTION 13

What are the two most relevant factors in determining the class of administration that is required to maintain the telecommunications infrastructure? (Choose two.)

 

A.

the size of the infrastructure

B.

the complexity of the infrastructure

C.

the age of the infrastructure

D.

the industry that the infrastructure supports

E.

the physical environment of the infrastructure

 

Correct Answer: AB

 

 

QUESTION 14

Refer to the exhibit. CCNA.com has the industrial network shown in the exhibit. All switches are configured as layer 2 switches and are using VLAN 1 as their management VLAN. Each VLAN 1 interface has been assigned the correct IP address. What is the purpose of assigning a default gateway to SW-C switch?

 

clip_image003

 

A.

allows connectivity between the VLAN 1 interface on SW-C and other devices in the network.

B.

allows connectivity between Host A and other devices in the network.

C.

allows connectivity between Host B and other devices in the network.

D.

allows the switch to pass traffic between Host A and Host B

 

Correct Answer: A

 

 

QUESTION 15

An administrator has connected devices to an industrial switch and, for security reasons, wants the dynamically learned MAC addresses from the address table added to the running configuration. What must be done to accomplish this?

 

A.

Enable port security and use the keyword sticky.

B.

Set the switchport mode to trunk and save the running configuration.

C.

Use the switchport protected command to have the MAC addresses added to the configuration.

D.

Use the no switchport port-security command to allow MAC addresses to be added to the configuration.

 

Correct Answer: A

 

 

QUESTION 16

Given a ring topology, which loop prevention mechanism provides the fastest reconvergence time after a link failure?

 

A.

Rapid Per-VLAN Spanning Tree Protocol

B.

Resilient Ethernet Protocol

C.

Multiple Spanning Tree Protocol

D.

Spanning Tree Protocol

 

Correct Answer: B

 

 

QUESTION 17

Which two ports does EtherNet/IP use to communicate? (Choose two.)

 

A.

TCP 44818

B.

UDP 44818

C.

TCP 502

D.

UDP 502

E.

TCP 2222

F.

UDP 2222

 

Correct Answer: AF

 

 

QUESTION 18

DRAG DROP

clip_image005

 

Correct Answer:

clip_image007

 

 

QUESTION 19

According to the Purdue Reference Model, at which layer would you perform manufacturing operations and control?

 

A.

Level 0

B.

Level 1

C.

Level 2

D.

Level 3

E.

Level 4

 

Correct Answer: D

 

 

QUESTION 20

Why is SSH preferred over Telnet as a method of accessing a network device to alter or view the configuration?

 

A.

Telnet encrypts only the login information, not the entire transmission.

B.

SSH requires fewer network resources and no additional configuration.

C.

Telnet is more difficult to use and configure than SSH.

D.

SSH encrypts the login and session information.

 

Correct Answer: D

100% Free Download!
—Download Free Demo:200-401 Demo PDF
100% Pass Guaranteed!
Download 2017 Ensurepass 200-401 Full Exam PDF and VCE Q&As:64
—Get 10% off your purchase! Copy it:TJDN-947R-9CCD [2017.05.01-2017.05.31]

Ensurepass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF + VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 Ensurepass IT Certification PDF and VCE