Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 Aug Cisco Official New Released 642-732
100% Free Download! 100% Pass Guaranteed!

Conducting Cisco Unified Wireless Site Survey V2

Question No: 41

What is the minimum CCX version necessary on a client when adding data points during WCS Calibration?

1. CCXv1

2. CCXv2

3. CCXv3

4. CCXv4

5. CCXv5

Answer: B

Question No: 42

When planning a site survey, what Cisco tool can an engineer use to estimate the number of required APs?

1. MSE Location Tracking

2. WCS Planning Mode

3. WLC NetFlow Exporter

4. LWAP Monitor Mode

5. WCS Map Editor

Answer: B

Question No: 43

A network engineer is conducting a Layer 1 site survey using a spectrum analyzer. Which four RF sources can be detected? (Choose four.)

1. Bluetooth

2. cordless phones

3. jammers

4. microwave

5. GSM phone

6. 3G phone

7. analog TV

8. infrared

Answer: A,B,C,D

Question No: 44

Refer to the exhibit.

The signal is being degraded to the point of link drops. You have examined the roof and the visual sighting of the remote antenna. What could be causing the issue?

1. The receiving antenna is too close to the transmitting antenna.

2. The first Fresnel zone is more than 60% blocked by the parapet.

3. The visual line of sight is more than 60% blocked by the parapet.

4. The cable between the APs and the antennae is introducing too much loss.

5. The roof material is absorbing too much of the signal.

Answer: B

Question No: 45

You have completed a WLAN site survey for a customer. Which two pieces of information will need to be included in the final customer report? (Choose two.)

1. Client association report

2. Client inventory

3. Printed cable scan certification results

4. Map location of all APs and controllers

5. WCS device inventory report of only the AP, WLC, and location server (MSE)

Answer: C,D

Question No: 46

Refer to the exhibit.

A company will start conducting an inventory of the outdoor yard area with 2.4 GHz bar code scanners. Which two Cisco recommended antennas should be used for the survey and mast mounting? (Choose two.)

1. AIR-ANT5959

2. AIR-ANT1949

3. AIR-ANT1728

4. AIR-ANT24120

5. AIR-ANT2506

6. AIR-ANT2410Y-R

Answer: D,E

Question No: 47

An engineer is conducting a VoWLAN survey for voice clients with a max power of 40 mW. What power level should the engineer set the AP to during the survey?

1. 5 mW

2. 10 mW

3. 20 mW

4. 30 mW

5. 40 mW

Answer: C

Question No: 48

Which choice best describes RF challenges for outdoor mesh site survey and deployment?

1. Reflection

2. Reflection, absorption

3. Diffraction

4. Diffraction, scattering

5. Reflection, absorption, diffraction, scattering

Answer: E

Question No: 49

Aside from software applications, which two tools will be important to have when performing a WLAN site survey? (Choose two.)

1. Measuring tools

2. Temporary attachment devices (tie-wraps, clamps, duct tape)

3. Architectural design drawings

4. Different sizes and types of wrenches and pliers

5. Portable battery packs to power WLAN clients

6. Flag tape to outline wireless cell dimensions

Answer: A,B

Question No: 50

What is the recommended method to protect a wireless outdoor bridge from lightning?

1. Install the wireless outdoor bridge in a grounded NEMA enclosure.

2. Install the wireless outdoor bridge inside a building if possible and only have the antenna outside.

3. Install a fiber-optic link between the wireless outdoor bridge and the antenna.

4. Install a one-meter segment of fiber-optic cable with a copper-to-fiber-optic transceiver to isolate the wireless outdoor bridge from the network cable plant.

5. Install a protection frame in the copper portion of the network cable plant to act as a lighting arrestor.

Answer: D

100% Dumps4cert Free Download!
–642-732 PDF
100% Dumps4cert Pass Guaranteed!
–642-732 Dumps

	Dumps4cert	ExamCollection	Testking
Lowest Price Guarantee	Yes	No	No
Up-to-Dated	Yes	No	No
Real Questions	Yes	No	No
Explanation	Yes	No	No
PDF VCE	Yes	No	No
Free VCE Simulator	Yes	No	No
Instant Download	Yes	No	No