642-732 Latest Exam (Aug 2018)

[Free] 2018(Aug) Dumps4cert Cisco 642-732 Dumps with VCE and PDF Download 61-70

August 8, 2018

Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 Aug Cisco Official New Released 642-732
100% Free Download! 100% Pass Guaranteed!

Conducting Cisco Unified Wireless Site Survey V2

Question No: 61

An engineer is deploying centralized wireless solution with a 5508 controller. What is the most AP licenses that can be supported?

A. 50 B. 100 C. 250 D. 500 E. 1000

Answer: D

Question No: 62

Refer to the exhibit.

Dumps4Cert 2018 PDF and VCE

What is the most likely cause of MAP1 association to MAP2 instead of directly to the RAP?

  1. Incorrect BGN

  2. Default BGN

  3. SNR

  4. Absorption and scattering caused by weather conditions.

  5. Incorrect radio configuration

Answer: C

Question No: 63

An engineer is tasked with designing a WLAN. The customer is prioritizing data speeds to the desktop, but is also entertaining the idea of adding 802.11 phones in the future. Given this information, how should the engineer conduct the survey?

  1. consider the employee head count in congested office space and limit the edge of each cell to an RSSI of -67mW

  2. restrict AP cell edges to -67dB and be sure to strategically place APs in congested office spaces

  3. co-locate access points when possible to cover high user areas and place APs at each corner of the facility

  4. stagger the AP placements, and be sure to have a high signal to noise ratio that will accommodate the future VoIP devices

Answer: B

Question No: 64

When designing and deploying an outdoor mesh network, what is the appropriate RF cell overlap?

  1. 10 percent

  2. 15 percent

  3. 20 percent

  4. 25 percent

  5. Application dependent

Answer: E

Question No: 65

An engineer wants to provide coverage between warehouse shelving stocked with bulk metal materials. What antenna would be adequate for performing this survey?

  1. 5.5 dBi omni down tilt

  2. 17 dBi grid

  3. 2.2 dBi omni

  4. 8.5 dBi patch

Answer: D

Question No: 66

A wireless engineer is gathering equipment to perform a point-to-point bridge survey. What three pieces of equipment should be used? (Choose three.)

  1. 3502i with dual band directional antennas

  2. 3502e with AIR-ANT2460NP-R

  3. 1132 with a 10dBi Yagi

  4. 1552e with three AIR-ANT2547-N=

  5. 1552e with AIR-ANT2588P3M-N=

  6. 1310 with internal antenna

  7. 1142 Series with internal antennas

Answer: B,E,F

Question No: 67

Which option will allow the maximum 2.4 GHz channel usage for a survey and voice deployment in the ETSI domain?

A. 1, 6, 11

B. 1, 5, 9, 13

C. 1, 6, 9, 14

D. 1, 6, 11, 14

Answer: A

Question No: 68

Which two types of information should be included in the installation inventory portion of the post-installation report? (Choose two.)

  1. All AP, controller, and MSE administrator credentials

  2. The number and type of all WLAN clients and tags

  3. The names, locations, IP addresses, MAC addresses, etc. for every AP, controller, and MSE in the WLAN

  4. Results of the coverage audit performed with the site survey mapping tool

Answer: A,C

Question No: 69

Which two details are specified in the Executive Summary section of the Site Survey Report? (Choose two.)

  1. proposed location for each AP

  2. customer and site surveyor contact details

  3. total number of APs

  4. expressed requirements set by customer

  5. coverage map

Answer: C,D

Question No: 70

How many location points are needed to validate both 802.11b/g and 802.11a in the Cisco WCS Calibration?

A. 50 B. 100 C. 150 D. 200 E. 300

Answer: E

100% Dumps4cert Free Download!
642-732 PDF
100% Dumps4cert Pass Guaranteed!
642-732 Dumps

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No