642-732 Latest Exam (Aug 2018)

[Free] 2018(Aug) Dumps4cert Cisco 642-732 Dumps with VCE and PDF Download 91-100

August 8, 2018

Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 Aug Cisco Official New Released 642-732
100% Free Download! 100% Pass Guaranteed!

Conducting Cisco Unified Wireless Site Survey V2

Question No: 91

Mesh APs are commonly mounted alongside a pole, meaning they are both vertically aligned and the pole could partially block the mesh AP RF signal. What is the maximum degree angle to allow for blockage of the antenna field of view?

  1. 2 degrees

  2. 5 degrees

  3. 10 degrees

  4. 15 degrees

Answer: B

Question No: 92

An engineer is preparing to conduct a site survey with AirMagnet. The engineer wants to capture all 802.11 traffic (not SSID specific) on the first walkthrough. Which survey mode should be used?

  1. active

  2. active with Iperf for greenfield: AP mode

  3. active with Iperf for greenfield: SSID mode

  4. passive

  5. planning mode survey

Answer: D

Question No: 93

A site survey proposes placement of new APs to replace older APs. Which three options are three potential placements of the new APs? (Choose three.)

  1. Use the old placements where they are near the proposed location.

  2. Add APs from the site survey that have no APs in older installation.

  3. Mount new APs on the exact location according to site survey report.

  4. Use network cables and mounting brackets from the older installation.

  5. Deploy APs every 4000 square feet.

  6. Deploy APs every 3000 square feet.

Answer: A,B,C

Question No: 94

What is the result if a client radio is incapable of supporting all the 5 GHz channels you have deployed in the controller or APs?

  1. You may only be able to deploy 20 MHz-wide channels.

  2. This may result in the client having to roam more frequently to find a channel it supports.

  3. This may result in coverage holes in the network.

  4. You may only be able to deploy 40 MHz-wide channels.

Answer: C

Question No: 95

What measurement can Iperf be used to verify?

  1. throughput

  2. RSSI

  3. SNR

  4. interference detection

  5. utilization

Answer: A

Question No: 96

What two factors could cause a post-deployment audit to show a high retransmission rate for the WLAN? (Choose two.)

  1. CRC errors

  2. Rate shifting

  3. CCX compatible clients

  4. High SNR values

  5. High RSSI values

Answer: A,B

Question No: 97

An engineer is surveying a customer site for additional wireless coverage. What two menus will an engineer navigate to in order to determine the maximum number of supported APs? (Choose two.)

  1. Monitor – Summary

  2. Controller – Inventory

  3. Management – Summary

  4. Wireless – Access Points

  5. Monitor – Access Points

Answer: A,B

Question No: 98 DRAG DROP

Dumps4Cert 2018 PDF and VCE


Dumps4Cert 2018 PDF and VCE

Question No: 99

You have been contacted by a medium sized medical center to do a site survey of their existing WLAN. The current network is set up with multiple SSIDs/VLANs to separate voice and data and the networks functioning properly. The medical center would like to add Vocera voice badges to the existing VoWLAN. Which two issues need to be considered during the site survey? (Choose two.)

  1. The additional voice endpoints may increase additional load, which may increase delay in the WLAN and cause voice quality to degrade.

  2. There will not be any issues due to adding the Vocera voice badges because they are point-to-point devices and do not require the infrastructure to communicate.

  3. Verify the WLAN is multicast enabled for Vocera voice badges.

  4. To make these devices as efficient as possible, the Vocera voice badges should be placed on their own unicast SSID/VLAN.

  5. Verify the WLAN that is being used by the Vocera voice badges is configured in the WLC to use the Gold QoS value.

Answer: A,C

Question No: 100

An engineer is deploying an outdoor Mesh network. What are the four major factors that should be considered? (Choose four.)

  1. line of sight

  2. power

  3. buildings

  4. mounting

  5. power lines

  6. satellite dishes

  7. network connectivity

  8. traffic lights

Answer: A,B,D,G

100% Dumps4cert Free Download!
642-732 PDF
100% Dumps4cert Pass Guaranteed!
642-732 Dumps

Dumps4cert ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No