300-365 Latest Exam (Aug 2018)

[Free] 2018(Aug) Ensurepass Cisco 300-365 Dumps with VCE and PDF 31-40

August 4, 2018

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 300-365
100% Free Download! 100% Pass Guaranteed!

Deploying Cisco Wireless Enterprise Networks

Question No: 31

A network engineer is experiencing issues enabling LAG on the WLC. Which four characteristics should be validated to ensure LAG configuration? (Choose four.)

  1. All ports participate in the LAG by default when LAG is enabled on the controller, y

  2. Dynamic interfaces and management are moved to port 1

  3. Primary and secondary ports are needed for each interface.

  4. Multiple untagged interfaces to the same port are not allowed.

  5. EtherChannel must be configured for mode quot;onquot; on the switch.

  6. Only one functional physical port is needed to continue to pass traffic.

  7. Multiple LAGs are permitted on the controller.

  8. The WLC does not need to be rebooted to enable the LAG configuration.

Answer: A,D,E,F

Question No: 32

A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs?

A. 802.11

  1. RRM

  2. High Density

  3. General

Answer: B

Question No: 33

A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured. How many image transfers between the WLC and APs will occur?

  1. 7

  2. 1

  3. 5

  4. 2

Answer: D

Question No: 34

A customer called into the support center with a problem ticket that involves wireless clients having to reauthenticate when they are walking around their office. After further investigation, it was discovered that the customer has two controllers in an N 1 deployment. Which action must the engineer take to troubleshoot the issue?

  1. Verify that the wireless controllers are in the same mobility group and that the access points are all on the primary controller.

  2. Under the SSID, make sure that 802.1 Iris configured and running for the clients.

  3. Make sure that the SSID has the authentication set to 802.1x with Cisco Centralized Key Management so the data clients can roam seamlessly.

  4. Verify the access points are spread out between the primary and secondary controller and that the controllers are in the same mobility group.

Answer: D

Question No: 35

Which of the following is not a Cisco RF fingerprinting key advantage over Location Tracking?

  1. Uses existing LWAPP-enabled Cisco Unified Networking components.

  2. Proprietary client hardware or software is required.

  3. Better accuracy and precision.

  4. Reduced calibration effort.

Answer: B

Question No: 36

VoWLAN implementation plans for a current mix of existing Cisco Unified Wireless IP Phones 7920G and 7921G to a final migration of Wireless IP Phones 7925G in a single WLAN. What would be the most appropriate WLC WLAN configuration to end with Wireless IP Phones 7925G?

  1. 7920 Client CAC = enabled only; Radio Policy = All; WMM = Disabled

  2. 7920 AP CAC = enabled only; Radio Policy = All; WMM = Allowed

  3. 7920 Client CAC = enabled only; Radio Policy = 802.11a only; WMM = Disabled

  4. 7920 AP CAC = enabled only; Radio Policy = 802.11a only; WMM = Allowed

  5. 7920 Client CAC = enabled only; Radio Policy = 802.11b/g only; WMM = Disabled

  6. 7920 AP CAC = enabled only; Radio Policy = 802.11b/g only; WMM = Allowed

Answer: B

Question No: 37

You are deploying a combination of Cisco Unified Wireless IP Phones 7921G and 7925G at your branch offices in a centralized call processing environment that requires high availability at branch locations. Which three components need to be verified before the wireless IP phones can be deployed? (Choose three.)

  1. Sufficient SRST license support at each branch location

  2. Support for local voice mail

  3. Branch gateways support MoH

  4. Properly configured QoS over the IP WAN links

  5. Support for single number reach

  6. Support for E.164 dialing

  7. Sufficient IP phone licenses in the Cisco Unified Communications Manager cluster

Answer: A,D,G

Question No: 38

You have just added a new MSE to Prime Infrastructure and want to synchronize the MSE with your 5508 WLC. which is located behind a firewall in a DMZ. You notice that NMSP messages are failing between the two devices. What traffic needs to be allowed on the Firewall to ensure the MSE and WLC can communicate using NMSP?

  1. UDP 16113

  2. TCP 1613

  3. TCP 16113

  4. UDP 1613

Answer: C

Question No: 39

You have set up FlexConnect APs. For which scenario is Fast Roaming supported, providing the WLAN is mapped to the same VLAN and the client is roaming to an AP on the same Cisco WLC?

  1. central switching with PMK (OKC) between different FlexConnect groups

  2. local switching with Cisco Centralized Key Management within the same FlexConnect group

  3. central switching with Cisco Centralized Key Management between different FlexConnect groups

  4. local switching with PMKID within the same FlexConnect group

Answer: B

Question No: 40

When a Vocera badge performs a broadcast call in a properly configured VoWLAN using WLC v7.0, which two choices indicate how the QoS is marked? (Choose two.)

  1. Upstream marked as Best Effort.

  2. Upstream marked as ToS CS4.

  3. Upstream marked as DSCP EF.

  4. Downstream marked as DSCP EF.

  5. Downstream marked as Best Effort.

  6. Downstream marked as Silver.

Answer: C,E

100% Ensurepass Free Download!
300-365 PDF
100% Ensurepass Free Guaranteed!
300-365 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No