352-001 Latest Exam (Aug 2018)

[Free] 2018(Aug) Ensurepass Cisco 352-001 Dumps with VCE and PDF 231-240

August 8, 2018

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 352-001
100% Free Download! 100% Pass Guaranteed!

CCDE鈩?Written Exam

Question No: 231 – (Topic 3)

In a network design, there are three distribution layers and one data center. What are the two main reasons for using a core layer in this design? (Choose two.)

  1. The use of a core layer provides Layer 3 capabilities to the campus.

  2. The core layer reduces the number of ports that are needed in the distribution layers.

  3. The core layer is needed when there are two or more distribution layers that are to be connected.

  4. The core layer would fulfill core network functions such as DPI and security policies.

  5. The core layer is capable of faster forwarding than any other layer or module in the network.

Answer: B,C

Question No: 232 – (Topic 3)

Company Y is a mobile backhaul provider that uses microwave rings in their network. Which low-cost, simple technology do you recommend to Company Y to ensure the fastest convergence times in a ring topology?

  1. sub-second IGP hello and dead timers

  2. MPLS Traffic Engineering

  3. Remote Loop-Free Alternate

  4. IP Event Dampening

  5. hub and spoke with ECMP

Answer: C

Question No: 233 – (Topic 3)

What should be taken into consideration when designing IPsec networks using Authentication Header (AH)?

  1. NAT

  2. transform set

  3. crypto maps


Answer: A

Question No: 234 – (Topic 3)

What is the purpose of dynamically created tunnels using IPv6 multicast?

  1. multicast source registration to the RP

  2. bypass of the RPF check to the RP

  3. transport of all IPv6 multicast traffic to the RP

  4. first-hop router registration to the RP

Answer: D

Question No: 235 – (Topic 3)

You are redesigning an OSPF v2 network and must migrate some links. You are concerned that there are different subnet masks. Which two link types will still form an OSPF adjacency even if there are subnet mask mismatches? (Choose two.)

  1. virtual

  2. broadcast

  3. point-to-multipoint

  4. non-broadcast

  5. point-to-point

Answer: A,E

Question No: 236 – (Topic 3)

A Service Provider network designer is considering the use of the G.8032 Ethernet Ring Protection mechanism in order to provide resiliency in the network. Which three concepts will be supported with the implementation G.8032? (Choose three.)

  1. Ring Protection Link (RPL)

  2. Ring Automatic Protection Switching (R-APS)

  3. Multi-Router Automatic Protection Switching (MR-APS)

  4. Automatic Protection Switching (APS) Channel

Answer: A,B,D

Question No: 237 – (Topic 3)

Which two options are characteristics of firewall transparent mode operations in a firewall solution design? (Choose two.)

  1. The firewall acts like a router hop in the network.

  2. OSPF adjacencies can be established through the firewall.

  3. Changes in the existing IP addressing and subnets are required.

  4. Multicast traffic can traverse the firewall.

  5. The firewall can participate actively on spanning tree.

Answer: B,D

Question No: 238 – (Topic 3)

Which two headend router scalability factors should be considered when designing a DMVPN network solution that uses a hub-and-spoke topology? (Choose two.)

  1. the required aggregated packet per second

  2. the amount of bandwidth necessary to terminate all the remote tunnels

  3. the routing protocol chosen for the data plane routing

  4. the maximum number of tunnels supported by the headend router

  5. the CPU and memory of the headend router

Answer: A,D

Question No: 239 – (Topic 3)

Which Designated Intermediate System selection option is valid when deploying IS-IS in a broadcast medium that connects two networking devices as a point-to-point network type?

  1. There is no DIS selection on point-to-point network types.

  2. The router with the highest interface IP address is selected as the DIS.

  3. The router with the lowest interface priority address is selected as the DIS.

  4. The router with the highest loopback IP address is selected as the DIS.

  5. The router with the lowest interface MAC address is selected as the DIS.

Answer: A

Question No: 240 – (Topic 3)

Which VPN technology supports multivendor interoperability on a network design?

  1. VTI

  2. DMVPN

  3. Easy VPN

  4. IPsec VPN

Answer: D

100% Ensurepass Free Download!
352-001 PDF
100% Ensurepass Free Guaranteed!
352-001 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No