Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 400-101
100% Free Download! 100% Pass Guaranteed!
CCIE Routing and Switching (v5.1)
Question No: 131 – (Topic 1)
Refer to the exhibit.
You are configuring Router1 and Router2 for L2TPv3 tunneling. Which two additional configurations are required to enable Router1 and Router2 to establish the
tunnel?(choose two)
-
Router1 must be configured to encapsulate traffic by using L2TPv3 under
thepseudowire-class R1toR2.
-
An IP address must be configured on interface FastEthernet1/0 on Router1.
-
Loopback 0 on Router1 must be advertised to Router2.
-
Cisco Express Fowarding must be disabled on Router1.
-
Cisco Discovery Protocol must be enabled on interface FastEthernet1/0 on Router1.
Answer: A,C
Question No: 132 – (Topic 1)
Refer to the exhibit.What are two effects of the given configurationChoose two
-
Track objiect 100 goes down if Ethernet1/0 goes down.
-
The aggregate weight of track object 100 is set to 30.
-
Track object 100 goes down if Ethernet1/2 goes down.
-
The aggregate weight of track object 100 is set to 40.
-
Track object 100 stays up as long as both Ethernet1/0 and Ethernet1/1 are up.
-
Track object 100 goes down if all three interfaces go down.
Answer: E,F
Question No: 133 – (Topic 1)
Refer to the exhibit.
Which kind of ICMPv6 packet is shownin the output?
-
Neighbor advertisement
-
Time exceeded
-
Neighbor soliciation
-
Router advertisement
-
Router discovery
Answer: C
Question No: 134 – (Topic 1)
Which two options are benefits of EIGRP OTP? {Choose two)
-
It fully supports multicast traffic.
-
It allow the administrator to use different autonomous system number per EIGRP domain.
-
It allow EIGRP routers to peer across a service provider without the service provider involvement.
-
It allows the customer EIGRP domain to remain contiguous.
-
It requires only minimal support from the service provider.
-
It allows EIGRP neighbors to be discovered dynamically.
Answer: C,D
Question No: 135 – (Topic 1)
Which three service offer VLAN transparency for WAN Ethernet services? (Choose three)
-
ERMS
-
EPL
-
ERS
-
MPLS
-
EMS
-
EWS
Answer: B,E,F
Question No: 136 – (Topic 1)
What are two of the commands that you can enter to gracefully shut down OSPF and notify neighbors?(Choose two)
-
router(config-if)# ip ospf graceful shutdown
-
router(config-if)# ip ospf shutdown
-
router(config-router)# shutdown
-
router(config-router)# graceful shutdown
-
router(config)# ip notify
Answer: B,C
Question No: 137 DRAG DROP – (Topic 1)
Drag each routing protocol on the left to the matching statement on the right.
Answer:
Question No: 138 – (Topic 1)
Which value does VPLS use to make forwarding decision?
-
Destination MAC of the the Ethernet
-
Destination IP address of the packet
-
Source MAC of the Ethernet frame
-
Source IP address of the packet
Answer: A
Question No: 139 – (Topic 1)
Which option is an incorrect design consideration when deploying OSPF areas?
-
area 0 – area 2-MPLS VPN superbackbone – area 1
-
area 2 – area 0 MPLS VPN backbone – area 1
-
area 1 – MPLS VPN backbone – area 2
-
area I – area 0 – MPLS VPN backbone – area 0 – area 2
-
area 1-MPLS VPN backbone-area 1
Answer: A
Question No: 140 – (Topic 1)
If you configure EIGRP redistribution on a router without specifying metric values.how the
router respond?
-
It assigns the lowest possible metrics
-
It uses K Values to assign new metrics
-
It uses the originating protocol metrics
-
It fails to enter redistributed routes into the route table
Answer: D
100% Ensurepass Free Download!
–400-101 PDF
100% Ensurepass Free Guaranteed!
–400-101 Dumps
EnsurePass | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |