Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 400-101
100% Free Download! 100% Pass Guaranteed!
CCIE Routing and Switching (v5.1)
Question No: 61 – (Topic 1)
Which feature must be enabled so that an IS-IS single topology can support IPv6 traffic?
-
extended metrics
-
adjacency checking
-
new-style TLVs only
-
both new-and old-style TLVs
-
old-style TLVs only
Answer: C
Question No: 62 – (Topic 1)
Under which two circumstances is IPsec transport mode appropriate ? (Choose two)
-
When both hosts are behind IPsec peers.
-
When the hosts are transmitting router management traffic.
-
When only one host is behind an IPsec peer.
-
When only IP header encryption is needed.
-
When IPsec peers are the source and the destination of the traffic.
-
When only IP header authentication is needed.
Answer: B,E
Question No: 63 – (Topic 1)
Which IPv6 migration method allows IPv4-only devices to communicate with IPv6-only devices?
-
Dual stack
-
NAT64
-
ISATAP tunnel
-
GRE tunnel
Answer: B
Question No: 64 – (Topic 1)
Exhibit:
Which option describes the meaning of this console message?
-
An EIGRP hold timer has expired.
-
FastEthernetO/O has interface errors.
-
An EIGRP process has been shut down.
-
An interface has gone down.
Answer: C
Question No: 65 – (Topic 1)
Which two options are potential impacts of microbursts? (Choose two.)
-
invalid checksum
-
tail drops
-
packet loss
-
unicast flooding
-
asymmetric routing
-
unnecessary broadcast traffic
Answer: B,C
Question No: 66 – (Topic 1)
Refer to the exhibit .
If R1 generated this response to the show debug command, which statement about its debug its debug output is true?
-
As soon as interface Fa0/0 becomes active, it generate debug output because one condition has been met.
-
When debug output is generated, only the user Cisco is permitted to view it.
-
R1 generates debug output as soon as IP address 192.168.0.0 is applied to interface Fa0/0.
-
RI generates debug output as soon as all three conditions are met.
Answer: A
Question No: 67 – (Topic 1)
Which IS-IS process is responsible for flooding local link information to adjacent routers ?
-
decision
-
receive
-
forward
-
update
Answer: D
Question No: 68 – (Topic 1)
Refer to the exhibit.
Which statement describes how a router with this configuration treats packets if the devices at 172.16.12.5 and 192.168.3.2 are unreachable ?
-
It routes the packet using the default routing table.
-
It routers the packet into a loop and drops it when the TTL reaches zero.
-
It drop the packet immediately.
-
It sends an ICMP source quench message.
Answer: A
Question No: 69 – (Topic 1)
Which three statements about AToM are true?(Choose three)
-
It requires Layer 3 routing between the PE and CE router.
-
It supports interworking for Frame Relay,PPP,andEthernet,but not ATM
-
It requires MPLS between the PE routers
-
The attachment circuit is configured with the xconnectcommand
-
IP CEF should be disabled in the PE routers.
-
The PE routers must share the same VC idenifier.
Answer: B,C,F
Question No: 70 – (Topic 1)
Which type of port would have root guard enabled on it
-
a designated port
-
an alternate port
-
a blocked port
-
a root port
Answer: A
100% Ensurepass Free Download!
–400-101 PDF
100% Ensurepass Free Guaranteed!
–400-101 Dumps
EnsurePass | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |