400-151 Latest Exam (Aug 2018)

[Free] 2018(Aug) Ensurepass Cisco 400-151 Dumps with VCE and PDF 121-130

August 11, 2018

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 400-151
100% Free Download! 100% Pass Guaranteed!

CCIE Data Center (v2.0)

Question No: 121 – (Topic 2)

Which two Cisco Nexus 2000 Series Fabric Extenders support FCoE? (Choose two.)

  1. 2248TP

  2. 2232ET-P

  3. 2224TP

  4. 2232PP

  5. 2232TM-E

Answer: D,E Explanation:

Ref:http://www.cisco.com/c/en/us/products/collateral/switches/nexus-2000-series-fabric- extenders/data_sheet_c78-507093.html

Question No: 122 – (Topic 2)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

Which statement about these commands is true?

  1. The outputs of the debug are redirected on file test on the quot;log.quot; directory.

  2. The outputs of the debug are redirected to the logging buffer.

  3. The command does not have an effect unless you configure quot;debug enablequot;.

  4. If you are on a console connection, the outputs are shown after the event occurs.

Answer: A Explanation: Ref:

http://www.cisco.com/web/techdoc/dc/reference/cli/nxos/commands/fund/debug_logfile.htm l

Question No: 123 – (Topic 2)

Which two statements about OTV are true?(Choose two)

  1. The authoritative edge device is the active forwarder for multicast and unknown unicast for all VLANs.

  2. The join interface must be a Layer 2 interface.

  3. no special license is required for OTV.

  4. OTV requires a separate VDC if SVIs for the extended VLANs are to be configured on the same switch.

  5. Only one join interface can be specified per overlay.

  6. OTV runs over a distance victor routing protocol. Answer: D,E

Question No: 124 – (Topic 2)

Which Ether type is used to identify FIP?

A. 0x8914 B. 0x8906 C. 0x8915 D. 0x8905

Answer: A Explanation:

Ref:http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/fcoe/513_n1_ 1/b_Cisco_n5k_fcoe_config_gd_re_513_n1_1/b_Cisco_n5k_fcoe_config_gd_re_513_n1_1


Question No: 125 – (Topic 2)

Which option is an advantage of Cisco ACE virtual IP address tracking?

  1. Troubleshooting is possible between multiple routing domains and multiple service devices.

  2. Tracking is limited to a maximum of 500 tracked instances.

  3. New virtual IP address implementation has multiple network touchpoints.

  4. It can be used during application migration in which virtual IP addresses cannot be changed.

Answer: D Explanation:

Ref: http://www.cisco.com/c/en/us/products/collateral/application-networking-services/ace- 4710-application-control-engine/guide_c07-572616.html

Question No: 126 – (Topic 2)

In a Cisco Nexus 7000 platform configured with GLBP, which GLBP timer can be tuned to prevent unnecessary GLBP state changes during a switchover or ISSU?

  1. GLBP redirect timer

  2. GLBP forwarder pre-empt delay minimum timer

  3. GLBP hold timer

  4. GLBP pre-empt delay minimum timer

  5. GLBP extended hold timer

  6. GLBP nonstop forwarding timer

Answer: E

Question No: 127 – (Topic 2)

Refer to the Exhibit.

Ensurepass 2018 PDF and VCE

Which two statements are true? (Choose two.)

  1. FC Zoning is going to be enabled automatically after the template is created.

  2. With the current fabric ID configuration on the vHBA template, cannot see the new VLAN

  3. All the required values have been configured in the vHBA template; after the VLAN is created, you can press OK start using the template.

  4. To modify the vHBA from the service profile in the future; you first must unbind the template from the vHBA fc0 template.

  5. VSAN and VLAN ID are assigned according to best practices.

Answer: B,D

Question No: 128 – (Topic 2)

When the administrator users the commit command to activate the changes to the call home configuration, it results in an error. Which is true?

  1. CSF must be disabled for this to work

  2. the commit call home command must be used

  3. CSF must be enabled for this to work

  4. The commit command is not required

Answer: C

Question No: 129 – (Topic 2)

Considering the ITIL v3 model, what are Puppet and Chef primary used for?

  1. problem management

  2. configuration management

  3. change management

  4. release management

Answer: B

Question No: 130 – (Topic 2)

What does the previously active supervisor do when quot;system switchoverquot; is issued?

  1. State is transferred and then becomes ha -standby.

  2. A core dump file is written, state is transferred, and the system resets.

  3. State is transferred; the supervisor reloads and becomes ha -standby.

  4. State is transferred; data plane operations are briefly suspended and then become has-tandby.

Answer: C

100% Ensurepass Free Download!
400-151 PDF
100% Ensurepass Free Guaranteed!
400-151 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No