400-151 Latest Exam (Aug 2018)

[Free] 2018(Aug) Ensurepass Cisco 400-151 Dumps with VCE and PDF 231-240

August 11, 2018

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 400-151
100% Free Download! 100% Pass Guaranteed!

CCIE Data Center (v2.0)

Question No: 231 – (Topic 2)

Which two statements about VACLs on Cisco Nexus 7000 Series Switches are true? (Choose two.)

  1. A single VACL can be shared across two or more VDCs.

  2. Use of VACLs requires no special license to be installed.

  3. VACLs make use of IP or MAC ACLs.

  4. Only options drop and forward are permitted.

Answer: B,C

Question No: 232 – (Topic 2)

Why is a Cisco UCS B250 server unable to support 16-GB DIMMs?

  1. Dual-rank DIMMs are not supported.

  2. 16-GB DIMMs are too slow.

  3. The largest DIMM an Intel 55xx or 56xx CPU can address is 32 GB.

  4. The memory bus would be too long.

  5. The blade would run too hot.

Answer: C

Question No: 233 – (Topic 2)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

Company ABC has implemented a Cisco TrustSec domain with an initial Cisco ACS server and Cisco Nexus 7000 CTS-DC.The company plans to extend the domain by adding an additional Cisco Nexus 7000 CTS-CORE. Which three minimum configurations are required on CTS-CORE to join the domain? (Choose three.)

  1. Configure TrustSec domain.

  2. Configure interface quot;cts dot1xquot;.

  3. Configure local device ID and password.

  4. Configure as a quot;non-seedquot; device.

  5. Configure feature dot1x and cts.

  6. Configure RADIUS authentication, authorization, and accounting.

Answer: B,C,E

Explanation: Ref:http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_1/nx- os/security/configuration/guide/sec_nx-os-cfg/sec_trustsec.html#wp1200631

Question No: 234 DRAG DROP – (Topic 2)

Drag and drop two configurations that should fail without data loss from the left column into the 2 Devices Lost column on the right.

Ensurepass 2018 PDF and VCE


Ensurepass 2018 PDF and VCE

Question No: 235 – (Topic 2)

Refer to me exhibit.

Ensurepass 2018 PDF and VCE

Which two statements are true? (Choose two.)

  1. VLAN segregation should be configured in Cisco UCS using VLAN Manager.

  2. VLAN segregation should be configured in Cisco UCS using PVLANs.

  3. when I hear segregation I think PVLANS

  4. The Fabric Feature cannot be used in this topology under any circumstances.

  5. Service profiles should contain a single vNIC per fabric, trunking VLAN 100-250.

  6. Not sure about a single vNIC but the other option says two NICS and service profiles use vNICS. Also you can configure multiple vlans per VNIC and enable fabric failover for the redundancy.

  7. service profiles should contain two NICs per fabric, with one trunking VLAN 100-150 and another trunking VLAN 200-250.

  8. VLAN segregation should be configured in Cisco UCS using pin groups.

Answer: B,D

Question No: 236 – (Topic 2)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

What is the cause of this error message?

  1. The local zone mode is enhanced and the remote zone mode is basic

  2. The local zone mode is basic and the remote zone mode is advanced.

  3. The local zone mode is default and the remote zone mode is basic.

  4. The local zone mode is advanced and the remote zone mode is enhanced.

Answer: A

Question No: 237 – (Topic 2)

Which three options are valid sources for Cisco UCS monitor sessions? (Choose 3)

  1. VHBA

  2. uplink FC interface

  3. VLAN

  4. vNIC

  5. VSAN

  6. pin group

Answer: A,B,E

Question No: 238 – (Topic 2)

The Cisco Nexus 1000v Series switches can configure traditional SPAN sessions. Which three statements about the local SPAN source ports are true? (Choose threE.

  1. It can be port type Ethernet, virtual Ethernet, or port-channel.

  2. It can be configured to monitor the direction of the traffic.

  3. It must be in the same VLAN.

  4. It cannot be on a different host VEM as the destination port.

  5. It cannot be a port profile.

  6. It must be in the same VSAN. Answer: A,B,D

Question No: 239 – (Topic 2)

Which type of port profile is used to dynamically instantiate vEth interface on the Cisco Nexus 5000 Series switch

  1. profile-veth

  2. vethernet

  3. vethinterface

  4. dynamic-interface

Answer: B Explanation:

Ref:http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/layer2/513_n 1_1/b_Cisco_n5k_layer2_config_gd_rel_513_N1_1/b_Cisco_n5k_layer2_config_gd_rel_51 3_N1_1_chapter_010101.html#task_ED8733E87FE84DA9B7D6829049DEC3DF

Question No: 240 – (Topic 2)

In the Cisco Nexus 7000 FabricPath domain, one switch becomes the root for the multidestination tree. Cisco FabricPath IS-IS will automatically select root switches for each multidestination tree. One of the parameters that is used to select the root is the system ID. Which two statements are true about the system ID? (Choose two.)

  1. The system ID is a unique 12-bit value.

  2. The system ID is a 48-bit value composed of the VDC MAC address.

  3. A higher system ID is preferred.

  4. A lower system ID is preferred.

Answer: B,C

100% Ensurepass Free Download!
400-151 PDF
100% Ensurepass Free Guaranteed!
400-151 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No