400-201 Latest Exam (Aug 2018)

[Free] 2018(Aug) Ensurepass Cisco 400-201 Dumps with VCE and PDF 1-10

August 11, 2018

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 400-201
100% Free Download! 100% Pass Guaranteed!

CCIE Service Provider Written Exam (V 4.1)

Question No: 1

On which two protocols is VNC based? (Choose two)

  1. Rdesktop

  2. Terminal Services Client

  3. TCP

  4. RFB

  5. UDP

  6. CoRD

Answer: C,D

Question No: 2

Which two sets of configuration implements CBTS? (Choose two)

  1. Create multiple MPLS TE from the same headend to the same tail-end

  2. Assign a policy-map defining a CBWFQ on an MPLS TE tunnel

  3. Create a master tunnel to which other tunnels can be members

  4. Create two bandwidth pools a global pool and a pool

  5. Create a PBR to use multiple MPLS TE tunnels according to the EXP value

Answer: A,C

Question No: 3

which option describes how NFV, OpenStack, and KVM relate to each other ?

  1. OpenStack and NFV enable KVM

  2. OpenStack and KVM can be used to provide NFV

  3. NFV and KVM are based on OpenStack

  4. OpenStack and KVM are not related to NFV

Answer: A

Question No: 4

Ensurepass 2018 PDF and VCE

A router has this error in the syslog message What issue has it reported ?

  1. The BGP label 3 can be used only in a BGP VPNv4 update for a directly connected VPNv4 prefix of the sending PE router

  2. The BGP label 3 can be used only in a BGP VPNv4 update for multicast address-family

  3. The BGP label 3 can be used only in a BGP VPNv4 update if the RD is 0:0

  4. The BGP label 3 can be used as a label for a VPNv4 prefix

Answer: D

Question No: 5

A backbone carrier is approached by an ISP_A which provides L3VPN services. The ISP_A requires MPLS VPN services from the backbone carrier to establish connectivity between the two POPs of the ISP_A. Which label protocol should the backbone carrier use to provide the proper connectivity that the ISP_A requires?

  1. L2TPv3

  2. L2TPv2

  3. LDP

  4. GRE

  5. mGRE

  6. BGP

Answer: A

Question No: 6

An operations engineer identifies a device is receiving a section loss signal alarm for a SONET link. Which action does the engineer perform?

  1. Verify that the framing format on the port matches the format configured on the line

  2. Verify that the alarm exists on the remote site

  3. Verify that the light level for the POS interface is within acceptable limits

  4. Verify the line status at the remote end of the link

Answer: C

Question No: 7 DRAG DROP

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

PE1 and PE2 has a Layer 2 VPN over a GRE tunnel. This GRE tunnel built between P1 and P2 has LDP enabled. Consider a packet capture of the packets from CE1 and CE2 at P1 and R1 link. Drag the headers on the left and drop them on the right in the order of the encapsulation, starting from the inner header (at the top) to the outer header (at the bottom).

Ensurepass 2018 PDF and VCE


Ensurepass 2018 PDF and VCE


Ensurepass 2018 PDF and VCE


Question No: 8

Which three components are required to support ISSU? (Choose Three)

  1. Supported line cards.

  2. SSO and NSF working.

  3. Redundant router for failover.

  4. Images that are preloaded into the file system.

  5. Traffic that is moved to another device.

  6. Active and standby RPs.

Answer: A,B,F

Question No: 9

An engineer is tasked with configuring Lawful-Intercept on the Internet facing routers. Which two security issues must the engineer take into consideration? (Choose two)

  1. Encryption might be required depending on the request

  2. SNMPv2c should be enabled in order to provide the correct message format

  3. QoS and CoPP should be implemented to protect and optimize the tasks

  4. The communication between the MD and the Content IAP happens over UDP port 161

  5. Default SNMP does not include all the MIB interfaces needed to respond to the request

  6. A new and dedicated loopback interface is required to communicate with the MD device

Answer: D,E

Question No: 10

A design engineer has a requirement to implement QoS with a high degree of granularity in traffic management on a service provider network. The QoS behavior must match these requirements

*Shape multiple queues to a single rate

*Specify the maximum transmission rate of a set traffic classes that are queued separately

*Shape the aggregate traffic of queues on a physical interface

Which deployment meets these requirements ?

  1. RSVP

  2. LLQ

  3. CBWFQ with WRED

  4. hierarchical QoS

Answer: D

100% Ensurepass Free Download!
400-201 PDF
100% Ensurepass Free Guaranteed!
400-201 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No