500-202 Latest Exam (Aug 2018)

[Free] 2018(Aug) Ensurepass Cisco 500-202 Dumps with VCE and PDF 11-20

August 19, 2018

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 500-202
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco Service Provider Mobile Unlicensed Small Cell Solutions

Question No: 11

To improve the user experience, Cisco Service Provider Wi-Fi networks should use authentication options that automate user authentication and no longer require the user to enter their credentials manually.

Which two authentication methods automate user authentication? (Choose two.)

  1. web (portal) login

  2. EAP-AKA


  4. EAP-SIM

Answer: B,D

Question No: 12

Which option is a requirement for a client when PMIPv6 is used in the Cisco Service Provider Wi-Fi environment?

  1. The client must be configured to support IPv6 and be assigned an IPv6 address.

  2. The client must be connected to the MAG through an IPv4-over-IPv6 tunnel.

  3. The client must run a dual-stack, that is, have both an IPv4 and an IPv6 address assigned to it.

  4. There are no special requirements for the client.

Answer: D

Question No: 13

Which three ways can be used to configure a wireless controller? (Choose three.)

  1. the AutoInstall process

  2. the AutoTune feature on an ISG

  3. automatic provisioning by CNR

  4. configuration push from CPI

  5. manual configuration via web GUI or CLI

  6. configuration downloaded from TR69 server

Answer: A,D,E

Question No: 14

How does 802.11r or fast BSS transition reduce the amount of time required for a client to roam?

  1. by allowing a client to pre-associate to multiple APs, which eliminates the need for the client to associate to a new AP when roaming

  2. by giving a new client priority in the AP scheduling mechanism, which gives a new client a faster response from the new AP

  3. by reducing the amount of authentication messaging between a client and a new AP, which means that the client does not need to renegotiate keys with the new AP

  4. by adding hand-off communications between the APs, which means that the old AP notifies the new AP when the client is about to roam

Answer: C

Question No: 15

Which two benefits does IEEE 802.11k – quot;Radio Resource Managementquot; provide to a Wi- Fi network? (Choose two.)

  1. If an AP is not servicing any wireless clients, it can shut itself down until it is put back into service by the wireless controller.

  2. A client can look at parameters other than signal strength to determine which AP to associate to.

  3. An AP can cause a dual-band client to prefer the 5 GHz 802.11a/n spectrum over the more-crowded 2.4 GHz 802.11b/g/n spectrum.

  4. An overloaded AP can direct a client to switch from it to another AP in the network.

Answer: B,D

Question No: 16

In the context of Cisco Service Provider Wi-Fi, what does the acronym MSAP stand for?

  1. Mobility Services Advertisement Protocol, which allows clients to query for local services before authenticating to a Wi-Fi network.

  2. Managed Security Association Protocol, which allows clients to maintain their authenticated sessions even while roaming on a Wi-Fi network.

  3. Multi-Station Access Protocol, which allows a single subscriber session to support multiple end-user devices simultaneously.

  4. Mobile Subscriber Awareness Protocol, which allows the Cisco ASR 9000 Series router to identify 3G/4G network subscribers#39; sessions and to apply policies to that traffic.

Answer: A

Question No: 17

Which option is a benefit of using Link Aggregation?

  1. The controller participates in trunk negotiation using LACP or the PaGP trunk negotiation protocol with the Ethernet switch on its links.

  2. Wired Ethernet frames can be fragmented and those fragments are sent simultaneously over multiple Ethernet links between the controller and the Ethernet switch, which provides the same improvement in data rate as 802.11n spatial streams provide for wireless traffic.

  3. If a link in a LAG fails, the controller switches traffic for that link over to the remaining link(s) in less than a second.

  4. A LAG allows the controller to be directly connected to other controllers, which eliminates the need for Ethernet switches.

Answer: C

Question No: 18

When a DHCP pool is created, how is the pool turned into a quot;dummyquot; pool?

  1. Disallow pings to verify if addresses are available to be assigned.

  2. Use the no dhcp enable command when the DHCP pool is configured.

  3. Set an exclusion range that contains all of the addresses that the pool would try to assign.

  4. Create the DHCP pool, but do not configure DHCP option 110.

Answer: C

Question No: 19

Which two methods should you use to verify that PMIPv6 functionality has been properly configured and is operational? (Choose two.)

  1. Verify that the IPv4 address that is assigned to the client is from the DHCP pool on the LMA.

  2. Perform an IPv6 ping from a client to the wireless controller.

  3. Use the PMIPv6 tunnel test command on the Cisco eWAG.

  4. Use show commands to verify the PMIPv6 tunnel and bindings on the MAG.

Answer: A,D

Question No: 20

Which three services are provided by the Cisco Mobility Services Engine? (Choose three.)

  1. Radio Resource Management

  2. Mobile Concierge

  3. Wireless Intrusion Prevention

  4. PMIPv6 Domain Roaming Coordination

  5. ThinkSmart Analytics

  6. Client Fast Roaming Services

Answer: B,C,E

100% Ensurepass Free Download!
500-202 PDF
100% Ensurepass Free Guaranteed!
500-202 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No